Spectraz Wrote:elektrovert Wrote:What's your setup?
How's your MIDI routed?
Cu-base can handle all that for sure as long as it's set up correctly.
Edirol UA25EX - http://www.rolandus.com/uploads/CMS/Prod...nt_gal.jpg
Cubase 4 Essential
Blofeld (usb only so far)
Oxygen 8 V2 midi controller.
The midi from Oxygen is plugged into the desktop, and the midi from the blofeld is also plugged into the desktop... I updated the driver so it recognizes the synth and managed to send it to a midi channel. However, I noticed that Cubase have shut down unexpectedly a few times since I plugged in my Blofeld.
OK, the only piece of gear from that setup I've used before is the Oxygen, so my advice mightn't be the best.
The Blofield has 16 parts, so you can run 16 parts at the same time.
make a midi channel in cubase, select the blofields midi out port from your routing section, set the midi channel to transmit on MIDI channel 1.
Repeat the procedure for all other midi channels.
that sets you up with your 16 channels for the Blofield.
when you select one of these channels in cubase you should be able to play it on the Oxygen.
You will also be able to select the presets through cubase too.
I'd imagine cubase's default setting is to recieve midi arriving at all midi ins, test this out by turning a dial on the Blofield and looking at the MIDI monitor, it should flicker as recieving info.
or select BLofield Midi channel 1 in cubase, select channel 1 in the blofield and hit record, when you adjust the filters or something on the blofiled the data should be recorded.
see if you can get that working.
Maybe someone who uses cubase would be better able to advise you.
Does cubase have anything like the enviroment in logic?